‎The Sky-Watcher/Orion SynScan hand controller is now available as an app on your smart device. Connect! The Full Feature mode is the most commonly used mode of operation. Page 18: Iterative Polar Alignment Without Polar Scope 6.8 iterative Polar alignment without Polar Scope Polar alignment of your mount by means of the polar-axis find- er scope is covered in the instruction manual for the mount. Use this app to control the AZ GTi mount or other Sky-Watcher/Orion AZ telescope mounts fitted with a SynScan Wi-Fi adapter. The Sky-Watcher/Orion SynScan hand controller is now available as an app on your smart device. 3. 3) Choose “SynScan_WiFi_####” in the Wi-Fi list available on your smartphone. 5) Open the SynScan app on your smartphone and tap on the “Connect” button at the top, your SynScan App will setup connection to the adapter and the mount. Do 1 star alignment or press up/down/left/right buttons on the app to see if the mount responds to App commands. This version of the SynScan app is suited for novice users using alt-azimuth mounts. Open SkySafari and enter the IP address of the phone, not the mount. 4) On an iOS device, wait up to 1 minute until the Wi-Fi icon appears in the notification bar. Only after the “Alignment” is done can the SynScan hand control’s high precise “GOTO” function be used to locate a celestial object. Open the app ; connect in EQ mode. Connect the iPad to the Skywatcher Wifi. Enter Port 11882. This app supports ASCOM on Windows PC. Use the Synscan App to align the mount. (There are a number of ways to do this. Use this app to control the AZ GTi mount or other Sky-Watcher or Orion telescope mounts fitted with a SynScan Wi-Fi adapter. SynScan recommends to keep the app open all times, so turn off display going to sleep on this device. For more info, visit www.skywatcher.com Use this app to control the AZ GTi mount or other Sky-Watcher/Orion telescope mounts fitted with a SynScan Wi-Fi adapter. Fig. Make sure the phone doesn't go to sleep. Connect the phone to the Skywatcher Wifi. In Cartes du Ciel, connect to the mount via ASCOM using the selection for "EQMOD ASCOM HEQ5/6". Leave the Synscan App running in foreground. Your device should most likely get 192.168.4.2 as the IP Address. Now, you can start your alignment process using Cartes du Ciel and EQMOD. This is the Pro version of the SynScan app and is … I use Cartes du Ciel to do a GoTo the alignment … The SynScan hand controller is now available as an app on your smart device. 1.4b Initialization Start Tracking Locate a celestial object manually After entering your coordinates into the relevant Synscan App and following a simple alignment procedure - you are ready to explore the universe using the App’s intuitive touchscreen menus. One type is soft ware- SynScan beeps and stops displaying the time.